Axiohm APOS PRINTER SERIES Manual de usuario descargar pdf (Pagina 19)

APOS KANJI User Manual Page 19 / 45

Ref : 3103039-FDE Issue A

Printer Control Codes

Control codes are non-printable characters or sequences of characters which affect the subsequent

operation of the printer. For your convenience, these are grouped below in logical sets of

commands which can be used in the same context.

Throughout the following descriptions of the commands you will note that three special codes are

used to cause the printer to interpret the following byte or bytes as part of a command and not as

printable characters. These codes are:

Code Name Dec. value Hex. value

ESC Escape 27 1B General “escape sequence” commands

GS Graphic Sequence 29 1D Often used for special graphic

commands

AX Axiohm 31 1F Special commands for the APOS printer

FS KANJI sequence 28 1C General Kanji commands

The general command syntax is as follows:

Command

(Description) Name and description of the command

(Format) The code sequence to be sent to the printer.

<nnh> is used to represent the hexadecimal number nn

<nn> is used to represent the decimal number nn

[ ] k is used when the sequence included in [ ] must be repeated k times

(Comments) Additional information such as range allowed for the numbers or default

values

(Cross reference) Related commands

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 44 45

Sin comentarios

Axiohm APOS PRINTER SERIES Manual de usuario Pagina 19