Axiohm A758 Guia de preparacion

1Wrenchman, Inc.10K120 Interfacefor2127 POS Printer ReplacementInstallation and Setup GuideNovember 13, 2003

10• Press the Enter key again.The 2127 should indicate MMM communications and the printershould print a message showing "27 applied 0 failed&quo

11Set the 10K120 Interface OptionsSee the options in the section below.• The 10K120 options can now be set by scanning the supplied bar codes.• If

1210K120 Interface Configuration Item Tag TableItem PLU No. DescriptionPrint Config Report 66394700101 Prints a receipt with the current 10K120interfa

1310K120 Interface Configuration Item Tag TableContinuedItem PLU No. DescriptionPower up MessageOFF66394700119 Disables the 10K120 firmware informatio

1410K120 Interface Configuration Item Tag TableContinuedItem PLU No. DescriptionView Journal 66394700129 Prints out the last transactions journal data

15Print the Journal data without erasing• Scan the "Print EJ Data" tag or enter the associated PLU numberRead MICR data from a check• Plac

16• Check that the printer is powered. A green light, located on the top of theprinter should be ON.• Verify that the printer configuration settings

17• Verify that the memory setting for Flash Journal Size in the printer is set to avalue other than 0.What if there is too much paper on the roll wh

18

192127 Register Back View

2IntroductionThe Wrenchman 10K120 interface enables the use of an Axiohm A758 or A760thermal printer with the NCR 2127 POS system.Advantages• Electro

3*** A758 – Diagnostics Form 7 ***••• Boot Firmware Revision : V3.10CRC : 184CP/N : 189-1076109C Flash Firmware Revision : V

4*** A760 – Diagnostics Form 8 ***••• Boot FirmwareRevision : V1.07CRC : 7CBAP/N : 189-7600131B Flash Firmware Revision : V1.14 CRC

510K120 Interface ConnectionsThe 10K120 interface consists of electronics enclosed in a small plastic case withtwo cable assemblies.NCR 2127 register

6Optional MICR connection• Connect the Wrenchman 10K96 MICR cable DB9-M connector to theDB9-F connector on the 10K120 “Y” or dual cable assembly.14•

7• Reset the 2127 register by pressing the "1" key twice.The display will show a line of "D"s with indicators.Changing Machine De

8Adjust Receipt FormatChanging Program 18 values will adjust the 2127 register receipt formattingoptions to match those needed by the Axiohm printer f

9Customize the 10K120 InterfaceThe 10K120 interface is customized with special PLU items. The items areentered into the 2127 using a PLU maintenance f